Black Friday: New Free Webinar!

Be sure to make time in between shopping and eating leftovers to dial in to a free webinar hosted by our friends at eApprentice.net! Details on the webinar are shown below. If you can’t make it, be sure to sign up so you can be notified when the recorded version is available to watch at your convenience.

Date/Time: November 28, 12:00 – 1:00pm PST

Colin Gilchrist will discuss what’s new in Mastercam X8!

2D
Dynamic Area, Core, and Rest have been combined into a single, more powerful, “Dynamic Milling” toolpath interface
New Feed Reduction and First Pass Offset
New Region Chaining gives you complete control over the tool entry/exits from the material
Dynamic Mill Toolpaths now extend to the stock when it is defined
Finish Pass Speed/Feed override now supported in 2D Contour

3D
3D HST Project now supports Depth Cuts
HST Finishing paths now support “Tilt Away”, which converts a 3X path to a 4X or 5X path. (requires a multi-axis license)
Multi-Axis Roughing – Dynamic motion can now be applied to a part using full 5 Axis toolpath motion.

Seating is limited, so sign up today!

https://www4.gotomeeting.com/register/667074999

Leave a Comment

*