Updating a NetHASP

Follow these steps to update a NetHASP to run Mastercam X. Perform these steps after installing Mastercam X. Click here to see instructions for a standalone HASP.

	Update NetHASP dialog box

1. Start the NHaspX.exe program. Click Start, Programs, Mastercam X, NHasp X.
2. Set the SIM type to NetHASP.
3. Set the Mode to Local. Please keep in mind that any type of remote access, remote desktop, remote terminal etc. are NOT supported.
4. Check the Serial number field. It should show the serial number of the SIM attached to your computer. Click here if 0 is displayed.
5. Check the message in the status area at the bottom of the dialog box. It should display Local NetHASP-nn found, where nn is either 20 or 50. Click here if it does not display this message.
6. Click the Update code file button and select the .NHCode file for the SIM attached to your computer. Typically, this file will be supplied to you by your reseller. The name and path of the update code file will display in the dialog box.
7. Click the Update button on the right side of the dialog box to update the SIM with the code.
8. Check the message in the status area. It should read, NetHASP-nn updated successfully, where nn is either 20 or 50.
9. Click OK to exit.