Updating a HASP

Follow these steps to update a standlone HASP to run Mastercam X. Perform these steps after installing Mastercam X. Click here to see instructions for a NetHasp.

Update HASP dialog box
Update HASP dialog box
  1. Start the HaspX.exe program. Click Start, Programs, Mastercam X, Hasp X.
  2. Check the Serial number field. It should show the serial number of the SIM attached to your computer. Click here if 0 is displayed.
  3. Check the message in the status area at the bottom of the dialog box. It should display HASP found. Click here if it does not.
  4. Click the Update code button and select the .HCode file for the SIM attached to your computer. Typically, this file will be supplied to you by your reseller. The update code will display in the dialog box.
  5. Click the Update button at the top of the dialog box to update the SIM with the code.
  6. Check the message in the status area. It should read, HASP#nnnnnn updated successfully, where nnnnnn is the serial number of your SIM.
  7. Click OK to exit.