Edit the machine definition so that it points to the network copy of the .control file and the new control definition

The final procedure is to edit the machine definition so that it points to the new, network version of the .control file, not the version on your local drive.

1. Start the Machine Definition Manager from the Machine Type menu.

   Note: If your part file already has an active machine group, you will first see an alert message about editing the current machine definition; click OK to continue.

2. Click the Open button and navigate to the network location where you copied the machine definition.

3. Select the desired machine definition and click Open.

4. Click the folder button under Control Definition.
   

5. Select the network folder with the new .control file and click OK.

6. Select the new .control file. Make sure that you see the network path as shown below.
   

7. Select the new post processor. Make sure that you see the network path as shown below.
   

8. Save the machine definition and exit.

Return to Moving machine definitions main page.