Configuring the Mastercam client workstations

Follow these steps to configure each Mastercam workstation to use the NetHASP.

1. Install Mastercam X.
2. Run NHaspX.exe. Set the SIM type to NetHASP and choose one of the following Mode settings:
   • If the PC is not the NetHASP Server, choose Network.
   • If the PC is also used as the NetHASP Server, choose Local.
3. Copy a properly configured nethasp.ini file to your main Mastercam directory (for example, c:\mcamx). This is not required, but is strongly recommended for optimum performance. Click here to learn more about configuring the nethasp.ini file.
4. Create or edit shortcuts for running Mastercam with command line switches to efficiently manage your licenses. Click here to learn more.

NetHASP drivers are automatically installed when you install Mastercam. If the installation procedure was not completed or if the NetHASP drivers were removed, Mastercam cannot recognize the NetHASP. To fix this problem, run haspdinst.exe from the Mastercam \common directory (for example, C:\mcamx\common).